Speedgoat IO397 D/A Setup
Speedgoat IO397 D/A Setup — The Speedgoat IO397 D/A setup settings.
This Speedgoat block performs the setup
and configuration to use the Speedgoat I/O modules. To use this block, open the HDL
Coder HDL Workflow Advisor and use it to generate a Simulink Real-Time interface
subsystem. This block is located inside the generated Simulink Real-Time interface
subsystem. The mask of this block controls the block parameters. Do not edit the
parameters directly. The FPGA I/O module block descriptions are for information
purposes only. The relevant parameters are promoted to the top level of the
generated Simulink Real-Time interface mask.
This driver block has no input or output ports.
FPGA Module Identifier - Unique identifier for FPGA I/O
1 (default) | n
Enter a unique number. This setting must match the setting of the
corresponding design under test (DUT) subsystem generated. This is
usually only relevant in a multi-module model, as otherwise the default
value 1 is applied. The module identifier ordinal sequence will also
correspond to the ordinal sequence of the modules' positions on the PCIe
bus. In this way such modules of the same device type can be uniquely
identified. For this reason, if multiple modules of the same type are
installed in the target machine and one module is not in use within a given model, a bus and slot for the
modules which should be used must be
FPGA Board Type - defines the I/O module
Select the correct I/O module.
D/A Voltage Span - D/A output range
+5V | +10V | ±5V | ±10V (default)
All analog outputs are directly connected to D/A pins. This parameter
is promoted to the top level of the generated Simulink Real-Time
Target Screen Output
This block does not produce any output on the target machine display.