IO114B - Digital output
IO114B - Digital output — Writes the IO114 digital
Simulink Real-Time - Speedgoat
Your model can only contain one of these blocks for each I/O module in your target
This driver block has n double-type scalar input ports, where n is the number of
selected digital output channels.
X (X is the digital output channel number)
Use the following values to set digital output channel X:
This ID defines the link to the corresponding Setup block.
Active Output Channels
Select the active output channels in a vector. A defined number of channels can be
selected using square brackets, for example, [1 2 3]. A sequence of channels can be
selected using a colon, for example, 1:4.
Define the initial signal level present on the outputs after the application has
been downloaded. The values can be set individually by entering a vector: the value
at a certain position in the Initial Values vector
is applied to the channel as defined in the enabled channels. A scalar value applies
to all the channels; for example, for individual values, type "[1 0 0 1]", and to
set all channels to zero, type "0".
Reset to Initial Values
Define whether the initial values are also applied once the application has
stopped. The behavior can be set individually for each channel using a vector. A
scalar value applies to all the channels; for example, for individual values, type
"[1 0 0 1]", and to set all channels to zero, type "0". "1" means use the Initial
Value and "0" means keep the latest value.
Defines the base sample time at which this driver block gets its sample hit. This
parameter can also be set to -1 for inherited
sample time. The units are in seconds.